If the under flow is between 10% and 55%, a “LOW” condition is generated. If the underflow is between 0% and 10%, this warrants a “FAIL”Ĭondition. NOTE: All alarms present within a short time before planting stops are frozen on the screen and the text LOW or FAIL will display on the LCD. The 60% segment of the bar graph remains onĪnd the row number continues to flash until the alarm condition is corrected. Pushing the OK to acknowledge the alarm will turn the alarm off. Under Flow Alarms - If the seed rate for one or more rows is less than 55% of the calculated average, theĬorresponding 60% segment will stay on, the corresponding row number starts flashing and the alarm sounds. SYS EC An internal error has been detected.Ģ. SYS LO The data communication lead (green) has been shorted to the ground lead (black). SYS HI The data communication lead (green) has been shorted to the power lead (white). The three possible data communication bus errors are: If a rotation shaft sensor is faulty, LSHAFT, RSHAFT or SHAFTS will display.Īnother type of system alarm occurs when the monitor detects a data communication bus error. Population) will be accumulated or displayed. No area related information (speed, field acres, total acres, seed spacing, seed When the distance sensor is faulty, the monitor will change to a bar graph only mode where the rows are The user can push the OK key to acknowledge theĪlarm. The type of sensor installed, and the audible alarm will sound. If the distance sensor is detected as faulty, the monitor will display either “PICKUP” or “RADAR”, depending on If the monitor detects a faulty sensor and there is no plantingĪctivity present, the monitor will scroll “CHECK CONNECTION”. The row number willĬontinue to flash until the alarm condition is removed. Pushing the OK key to acknowledge the alarm will turn the beeper off. The corresponding row number starts flashing and the beeper sounds. System Alarms - A system alarm is entered when the monitor detects a faulty sensor or one of several other Row spacing reverts back to its programmed setting.ġ. Tubes connected and the monitor powered up, the monitor will again show seed population and seed spacing in inches The seed spacing and seed population functions are not available in this mode.
Implement width in feet (or meters) is programmed into the monitor, the monitor will function as an acre counter. G1K249 Acre Counter Switch Kit) instead of the seed tubes and (c) the Is connected to a sensing switch (Part No. If (a) the monitor is connected to a radar distance sensor, (b) the signal cable from the back of the console If the monitor is installed with only a radar distance sensor (no seed tubes attached), the monitor becomes a Press The DOWN Key Left Most Digit 1083, 0500, (Min. Press The MODE SELECT Key Twice Left Most Digit 2083 Press The MODE SELECT Key Second Digit From Right 2033
Press The UP Key Right Most Digit 2031, 2032, 2033 The word “DONE” MUST be displayed in order for the save to have occurred. If the OK key is released BEFORE the word “DONE” is displayed, the changes WILL NOT BE After a short time a long beep is heard, and the lower LCD will display the word “DONE”. The monitor will emit several short beeps and SAVE? icon is STEP 4 To exit and save, press and hold the OK key. NOTE: Clearing the total area counter will also clear the field area counter.
Once cleared, the user may not choose toĮxit programming mode without saving as described in Step 4. The long beep, the previous recorded total area is not retrievable. When the data is actually cleared, the monitor will emit a long beep, and the field area is reset to zeros. The CLEAR? icon will be displayed and the monitor will beep several times.